Designing the denture base

Aus Amann Girrbach
Wechseln zu: Navigation, Suche
Fahne Deutsch.JPG



Reiter „Ändern/ Zeichnen“ (Correct/Draw) [1]

84.png



In the following Wizard step “Design prosthetic base” under the tab “Change/Draw” [1] the outline of the denture base to be generated can be defined by placing points on the margin of the mucobuccal fold. Once all the points have been placed, they are either confirmed by a double click of the left mouse key or with button “Accept marked line“ [2]. The denture base is then generated with a click on the button “Apply” [4].

85.png


WarningThe “Clear” button [3] only deletes the previously drawn line, but not a previously generated base. There must be a base and a line present to exit this Wizard step using the “Next”.




“Properties” tab [1]

86.png




There are various possibilities of influencing the initially loaded base under the tab “Properties” [1].

In the field “Surface Properties” [2], the slide control “Base” can be used to define the minimum thickness at the thinnest section of the base. The “Cervical” slide control influences the thickness of the papilla form and the “Smoothing” value can be used to set how much the surface of the base should be smoothed.









“Detect” tab [1]

87.png




The periphery of the base can be automatically detected by the software with the aid of the Detect function.

Four points are placed as wide apart as possible at mucobuccal fold positions. Once the four points have been placed, generation of the periphery line starts automatically.

Manual adjustment of the periphery cannot be ruled out due to the individual morphology of an edentulous upper or lower jaw. This requires switching again to “Change/Draw” and adjusting.








“Gingival Margin” tab [1]

88.png


The cervical gingival margin of the wax base at the denture teeth can be custom adapted in this tab.

The green points can be dragged to any position by pressing the left mouse key. The denture base the base is generated up to the defined gingival margin (green line) during creation of the denture base.