Freeforming the denture base

Aus Amann Girrbach
Version vom 26. November 2015, 08:45 Uhr von WikiSysop (Diskussion | Beiträge) (Example 2: Detailed papillae -alveoli modelation)
(Unterschied) ← Nächstältere Version | Aktuelle Version (Unterschied) | Nächstjüngere Version → (Unterschied)
Wechseln zu: Navigation, Suche


The “Freeforming” tool is available for contouring the denture base. This tool provides the possibility of processing the outer design of the denture base.


“Anatomical” tab [1]

91.png






Smaller “Denture Base Parts” [2], or also “Entire Denture Base” [3] can be moved under the “Anatomical” tab [1].

The respective button is activated for this and the required denture part is dragged towards where more base material is needed while keeping the left mouse key pressed.








Tab “Free” [4]

92.png







Under the tab “Free” [4] it can be selected whether to “Add/Remove” or “Smooth” the material. The required thickness, size and type of brush can be set in the area “Brush” [6].







Example 1: Quick alveoli modellation

1. The Gingival section of the denture base is slightly cut in using the “Parts of the denture base” tools under the “Anatomical” tab.

2. The relevant alveolus is slightly accentuated with the same tool.

3. The surface of the modellation is then smoothed using the “Smooth” tool.



Gleich.png
97.png




Example 2: Detailed papillae -alveoli modelation

1. The base surface of the alveoli is created using the “Add/Remove” tools and the brush type “Standard”.

2. The cervical papillae are created using the brush type “Cylinder” and a slightly smaller selected setting of the brush size.

3. Finally the surface of the pattern is smoothed using the “Smoothing” tool.



Gleich.png
102.png