M-Part Modellvermessung: Unterschied zwischen den Versionen

Aus Amann Girrbach
Wechseln zu: Navigation, Suche
Zeile 43: Zeile 43:
 
<br/>
 
<br/>
 
{{Nav|Next: [[M-Part Ausblockung bearbeiten|Ausblockung bearbeiten]]}}
 
{{Nav|Next: [[M-Part Ausblockung bearbeiten|Ausblockung bearbeiten]]}}
<br/>
+
{{Nav|Zurück: [[Ceramill M-Part|Ceramill M-Part Übersicht]]}} <br/>
{{Nav|Next: [[Ceramill m-part|Ceramill m-part Overview]]}} <br/>
 

Version vom 16. November 2017, 15:50 Uhr

Fahne Englisch.jpg



In the Survey tool you specify the insertion direction of partial relative to the navy-blue scan. Left-click anywhere on the scan and the insertion path arrow changes from white to red, and the cursor changes to a 4-arrow cross. Left-drag to rotate the model to the desired insertion path, when you release the mouse button, the undercut colors will update. If you need to determine the exact amount of undercut in a particular area, use the right-drag mouse button to rotate the model so the area in question is visible. You can continue to change the insertion angle to adjust to the desired undercut depth.

Alternatively, you can rotate the model so that you are looking at the model from the desired insertion path and click Set From View [3]. To reset the path of insertion to the original default z-axis, click Default Insertion [2].

Click Apply [6]to generate a purple refractory model with light-blue "blockout wax" in the undercuts. This may take a few moments. Use Ctrl-Z to undo.

You can change the view orientation of the main image with either the arrows in the lower portion of the expert toolbar, or F2 through F5 keys.

M-part survey Toolbar.png

You can change the scale of the undercut colors by editing the top number in the undercut color scale Settings... [1].
To prevent any blockout from being done, un-check the Block Out Undercuts [4] box. This is rarely used.
You specify the desired blockout wax Draft Angle [7], using the slider or by typing in a number. Typically 2-3 degrees is sufficient. Zero degrees (the default), may create tight partial frameworks.
Apply [8] takes the current path of insertion and generate a purple refractory model with light-blue "blockout wax" in the undercuts. This may take a few moments. If you are unhappy with the results, use Ctrl-Z to undo and re-set the parameters.
Click Next to proceed to the next step.

Settings

M-part survey settings.png



You can adjust the undercut color scale depending on your preference. Left-click on the top number of the scale [7], and edit it to adjust the maximum value. The mid-scale [8] will adjust accordingly.