Placing saw cuts and positioning model pins are the final steps in creating an AG Inhouse model.
The number of saw cuts to be placed can be changed under the Planes  tab. The left mouse key should be clicked on one of the circles  between the teeth of the dental arch to remove or add a saw cut.
The "Automatically hide base plate"  function is activated as default. This hides the base plate automatically as soon as it is likely to obscure the view of the scan data.
Generation of the model segments is started by activating the Start button . It should first be ensured that all saw cuts are correctly positioned and pins to be taken into consideration have been selected.
Positioning and customising the saw cuts
The saw cut must be positioned, so as to prevent contact with a preparation taking into account the width of the gap. If a saw cut is placed too close to the preparation margin, the base of the crown is marked red and the position must be corrected.
The saw cuts can be changed in four different ways:
1. Rotating the saw cut
The saw cut can be rotated about the yellow point by clicking the left mouse key on a green point .
2. Positioning the saw cuts
The saw cut can be dragged to any position by pressing the left mouse key on a yellow point .
3. Adjusting the height of the saw cut
The height of the saw cut can be adjusted by simultaneously pressing the Control key and the left mouse key on a yellow point .
4. Inclining the saw cuts
The saw cut can be inclined by simultaneously pressing the Control key, Shift key and the left mouse key on the surface of the saw cut .
Selection of the pin holes
The required pins are marked by a left click in this step for subsequent positioning and fixation of the model segments on the MM base plate. The marked pins are highlighted in yellow.
Once all saw cuts and pins have been correctly positioned and aligned, model generation is started by activating the Start button .